Mounting Philips 10BDL5051T screen to wall

This guide shows how to mount the Philips 10BDL5051T doorframe display to a wall. The installation is done by the customer, but our support is happy to help if anything is unclear.

Before you start

• Power over the network cable: the display gets both power and network from the same cable. You need a PoE+ switch or injector (IEEE 802.3at). Standard PoE may not be enough, as the display can draw up to 18 W.
• Cable: a Cat5e or Cat6 network cable at the mounting spot. It is a good idea to bring the cable out of the wall so that it stays hidden behind the display's back cover.
• Tools: a screwdriver and screws that suit the wall material.
• Mounting height: we recommend placing the center of the display about 120–140 cm (47–55 in) above the floor. This follows the reach ranges in the EU accessibility standard EN 301 549, so the display is easy to read and use, also from a wheelchair.

Mounting

1. Loosen the screws on the back cover with a screwdriver.
2. Carefully loosen the back cover and detach it from the display.
3. Screw the back cover to the wall where you want the display.
4. Plug the network cable into the display.
5. Attach the display to the back cover on the wall.
6. Fasten the screws again.

The display can be mounted horizontally or vertically. Systam Rooms rotates to the right orientation automatically.

You can also watch the installation in this short video:

After mounting

• How to setup network for Rooms device (Philips 10BDL5051T)
• Troubleshooting Systam Rooms displays

That's it, your display is in place and ready to go.